← All resources

Windows

[SOLVED] SCCM Task Sequence Error 0x80091007

3 solutions to help you resolve error 0x80091007 that can occur during operating system deployment.

During an SCCM operating system deployment, a task sequence may fail with error 0x80091007 and the following message:

0x80091007 — The hash value is not correct

Although relatively uncommon, this error is typically related to content corruption, a download issue, or in rare cases a hardware problem on the target device.

What Causes Error 0x80091007?

Error 0x80091007 is a hash validation error. It indicates that the SCCM client downloaded a package (operating system image, application, driver package, etc.) from a Distribution Point, but the downloaded file does not match the expected hash value.

Several factors can cause this issue:

  • Corrupted or incomplete content on the Distribution Point
  • Binary Differential Replication (BDR) issues
  • Hardware problems (such as faulty RAM) causing temporary data corruption

Possible Solutions

Redistribute the Affected Package

In most cases, redistributing the content resolves the issue.

  1. In the SCCM Console, navigate to:
Software Library > Application Management > Packages

(or Operating System Images, depending on the content type)

  1. Right-click the affected package or image and select:

Remove from Distribution Point

  1. Once the removal is complete, redistribute the content to the affected Distribution Points.

  2. Retry the task sequence.

Good to Know

📝 Verify that the package size, version, and content hash are consistent across all Distribution Points.

Disable Binary Differential Replication (BDR)

If the error occurs while downloading a WIM operating system image, the issue may be related to Binary Differential Replication (BDR).

BDR optimizes content distribution by transferring only modified blocks. In rare situations, corruption can occur if the differential data becomes inconsistent.

Steps

  1. Navigate to:
Software Library > Operating Systems > Operating System Images
  1. Right-click the affected image and select Properties.

  2. Open the Data Source tab.

  3. Uncheck:

Enable binary differential replication
  1. Redistribute the image to all Distribution Points.

Good to Know

💡 BDR is useful for reducing network traffic, but temporarily disabling it can help during troubleshooting and deployment testing.

Test Another Device or Replace Faulty RAM

If the problem continues to occur on a single device despite successful content redistribution:

  • Test the deployment on another computer.
  • Test on a different hardware model if possible.
  • If the deployment succeeds elsewhere, consider a hardware-related issue.

Good to Know

Faulty RAM is one of the most common hardware causes of error 0x80091007. Temporary read/write corruption can alter downloaded content and cause hash validation failures.

Recommendation

Run a memory diagnostic using:

  • MemTest86+
  • Windows Memory Diagnostic

If memory errors are detected, replace the RAM and test the deployment again.

Error 0x80091007: Conclusion

Error 0x80091007 is generally straightforward to resolve when it is caused by content corruption.

Before investigating potential hardware failures, consider the following actions:

  • Redistribute the affected content
  • Temporarily disable Binary Differential Replication (BDR)
  • Test the deployment on other devices

These simple troubleshooting steps can save considerable time and help restore a reliable deployment process.

Maintaining healthy and properly replicated SCCM content across Distribution Points remains one of the best ways to prevent this type of issue in enterprise environments.